Features:

• Fast Set-ups
• Reduced Floor Space
• Quick Playback
• Rapid Cycle Times
• Reduced Energy Cost
• Low Labor Cost

The Tring Corporation is the leader in hole saw forming equipment and has over 12 years experience in automatic forming systems. Together with  a leading furnace builder, we designed a superior integrated loading, treating furnace, forming and unloading system.

This proven system combines improvements in the loader former and a furnace design specifically for hole saw forming. The controls have been combined into a single PLC that allows control of loader operation, furnace temperature, hearth indexing, atmosphere, die cooling and former.

Special Furnace
Tring Corporation has partnered with furnace builder Seco/Warwick Corporation, Meadville, PA, to build a furnace specifically for hot forming of hole saw blades. The robust furnace offers the benefits of a hearth with accurately located slot locations. This furnace uses an indexer rather than a complex servo drive for years of dependability. 

This special furnace allows us to offer a double system where two loaders and two unloaders are used with one furnace. This not only reduces capital cost, it also reduces operational cost and saves floor space in your plant. The104cm ( 41") furnace will handle blades up to 15cm (6") diameter and will allow a double forming system to be applied now or at a later time.

Quick Set-up
Innovations such as quick-change tooling and Fast Purge have been developed to keep your forming system up and running. Our quick-change tooling allows quick change over from one size to another. On our double system, two different size blades can be run at the same time. Water cooled tooling allows fast cycle times.

Product Size Range

Our  standard systems will produce hole saws 1.9cm (3/4") diameter through 15 cm (6") diameter, heights from 3.4cm (1.375") through 5.7cm (2.25") and thicknesses from 1.06mm (.042") to 1.27mm (.050"). Other sizes can  be accommodated with modifications.

Cycle time is adjustable from the operator interface panel. Average cycle time is 12 seconds, thus producing 5 hole saws per minute per line. This is based on a 4 second quench time in the dies and 2 minutes soak time in the furnace. Changing quench time or soak time will directly effect the cycle time. A double system will produce two blades each cycle.

Give us a call today for more information and a quote!

Ask for a copy of a DVD showing our hole saw forming system!
 

Read New Releases